Qvidium StreamViewer Manuel d'utilisateur télécharger pdf (Page 8)

User’s Manual QVidium™ StreamViewer

Stream Profiles and Play Out

4.1

Stream Profiles

StreamViewer’s main window displays a list of pre-

configured stream profiles. Initially, no pre-

configured profiles exist. Clicking on “New

Stream…” allows you to create new stream profiles.

It pops up the New Stream… panel as shown at

right. Most of the parameters can generally be left at

their default values for most common modes of

operation. The two key parameters to configure are

the profile name and UDP port. After assigning a

name to the profile and verifying that the UDP port

corresponds to the port of the stream you wish to

receive, click OK to write the new profile and return

to the profile list. You can later modify these settings

by single-clicking on the profile to edit (highlighting

it) and then clicking on Edit under the Stream menu.

StreamViewer automatically detects the format of the

incoming video stream. It automatically handles both

MPEG-2 Transport streams over either UDP or

RTP/UDP packet formats. It can also automatically

detect and play out either MPEG-2, MPEG-4, DV, or

DVCProHD formats. There is no need to configure

this separately. The Video Parameters area of this

setup window only applies if the incoming stream is

in DVCProHD format. If not using DVCProHD, you

can ignore these settings.

Figure 2: New stream profile form.

Unless you are configuring the StreamViewer for IPTV from a QVidium IPTV video

server, you should leave the Stream Replicator IP address blank.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Qvidium StreamViewer Manuel d'utilisateur Page 8